ICON A5 - Cockpit Floor Board Removal

3-46 INSPECTIONS / GENERAL INSPECTION TASKS
ICON A5 / MAINTENANCE MANUAL CHANGE C2
CHAPTER 3
4. Install the baggage floors. (See “Baggage Floor Installation” on page 3-42.)
5. Install the headliner. (See “Headliner Installation” on page 3-38.)
VERIFICATION METHOD:
The task is completed when the baggage sidewall panel has been installed.
RELATED INFORMATION:
"Baggage Floor Installation" on page 3-42
"Seat Belt Inertia Reel Installation" on page 3-40
"Headliner Removal" on page 3-37
"Install Fuel Bladder (MY17 Only)" on page 10-12
"Rigging Roll Controls" on page 9-20
"Inspect Roll Cable Tension" on page 9-13
"Rigging Yaw Controls" on page 9-87
"Rigging Pitch Controls" on page 9-46
"Inspect Yaw Cable Tension" on page 9-80
"Install Fuel Tank (MY18+)" on page 10-19
3.6.2.9 Cockpit Floor Board Removal
The following procedure is used to remove the cockpit floor board.
TASK INFORMATION:
Type of Maintenance
Line
Level of Certification
LSA-RM
Task Specific Training Required
No
Special Tools Required
None
Parts Required
None
Aircraft System and Number
NA
Consumables
None