ICON A5 - Maintenance Instructions; Remove Dome Light Switch

6-64 ELECTRICAL SYSTEM / DOME LIGHT SWITCH
ICON A5 / MAINTENANCE MANUAL CHANGE C2
CHAPTER 6
6.9.3 Maintenance Instructions
6.9.3.1 Remove Dome Light Switch
Use the following task to remove the dome light switch.
TASK INFORMATION:
Type of Maintenance
Line
Level of Certification
A&P
Task Specific Training Required
No
Special Tools Required
None
Parts Required
None
Aircraft System and Number
03—Electrical System
Consumables
None
TASK INSTRUCTIONS:
1. Remove the overhead console bezel. (See “Overhead Console Component Replacement” on
page 13-15.)
2. Carefully remove the connectors from short and long posts on SWITCH, SPST, 30A. (See Figure
6-17.)
3. Remove the retaining nut and remove the dome light switch from teh overhead console.
VERIFICATION METHOD:
The task is completed when the switch has been removed.