ICON A5 - Use of VHB Tape for Installations and Repairs

4-12 STRUCTURES / USE OF VHB TAPE FOR INSTALLATIONS AND REPAIRS
ICON A5 / MAINTENANCE MANUAL CHANGE C2
CHAPTER 4
4.3 Use of VHB Tape for Installations and Repairs
VHB tape is used for installation and repair. Specifically it is used to repair vortex generators, stall
strips, and flap fences.
TASK INFORMATION:
Type of Maintenance
Line
Level of Certification
A&P
Task Specific Training Required
No
Special Tools Required
3M
®
Adhesion Promoter 111
Parts Required
None
Aircraft System and Number
Consumables
70006738424; 3M
®
VHB Tape 5915WF White, 1/2 in, 16 mil
70006738531; 3M
®
VHB Tape 5952WF White, 1/2 in, 45 mil
70006436714; 3M
®
VHB Tape 5915 Black, 1/2 in, 16 mil
TASK INSTRUCTIONS:
1. Remove existing VHB from component and attaching surface. When removing a component
attached with VHB tape, gradually soften and loosen the tape with isopropyl alcohol until the
component can gently be worked free.
CAUTION: Do not forcibly remove the component as damage to the underlying
structure could result.
2. Clean both surfaces with mild soap and water solution and dry, then wipe surface with isopropyl
alcohol and dry using a lint free cloth.
3. Apply 3M
®
Adhesion Promoter 111 to the cleaned mating surfaces. Allow to dry completely prior
to the application of tape.
4. Locate the affected component per its associated installation drawing. Contact ICON Aircraft for
the appropriate installation drawing as listed below the task steps.
5. Apply the specified VHB Tape to the affected component.