ICON A5 - Right Instrument Panel Top Panel Installation

8-18 EQUIPMENT AND FURNISHINGS / EQUIPMENT AND FURNISHINGS GENERAL MAINTENANCE
ICON A5 / MAINTENANCE MANUAL CHANGE C1
CHAPTER 8
TASK INSTRUCTIONS:
1. Remove Center Console Bucket.(See “Center Console Bucket Removal” on page 8-5.)
2. Remove the throttle handle and bezel.(See “Throttle Handle and Bezel Removal” on page 8-10.)
3. Remove the two kneepads by carefully peeling them off. They are held on with hook and loop
tape.
4. Remove the GPS mount and Radio stack bezel. (See “GPS Mount and Radio Stack Bezel
Removal” on page 8-15.)
5. Remove the vent air hose at right side instrument panel by loosening the worm drive clamp.
6. Remove the right eyeball air valve using ICON eyeball vent tool ITL001563.
7. Remove the 6-32 screw behind the right eyeball air valve with a #2 right-angle crosshead driver.
Remove the 8-32 screws at the forward-right side and at aft-left corner of the right instrument
top panel with a T15 Torx driver. Remove the right instrument top panel.
VERIFICATION METHOD:
The procedure is complete when the entire right instrument top panel has been removed.
RELATED INFORMATION:
"Battery Removal and Installation" on page 6-37
"Heater Fan and Core Removal" on page 7-3
"Multiple Systems Controller (MSC) Replacement" on page 13-27
"Canopy Removal" on page 11-3
"Canopy Installation" on page 11-4
"Nose Landing Gear (NLG) Leg Assembly Removal" on page 14-60
"Remove Landing and Taxi Lights" on page 6-58
"Landing Gear Actuator Limit Switch Adjustment Procedure" on page 14-19
8.2.9 Right Instrument Panel Top Panel Installation
Use this procedure to install the right instrument panel top panel.
TASK INFORMATION:
Type of Maintenance
Line
Level of Certification
LSA-RM
Task Specific Training Required
No
Special Tools Required
T15 Torx driver