ICON A5 - Instrument Panel Center Spine Removal and Installation

8-22 EQUIPMENT AND FURNISHINGS / EQUIPMENT AND FURNISHINGS GENERAL MAINTENANCE
ICON A5 / MAINTENANCE MANUAL CHANGE C1
CHAPTER 8
4. Install the Center Console Bucket. (See “Center Console Bucket Installation” on page 8-8.)
5. Install the GPS in its mount.
VERIFICATION METHOD:
The procedure is complete when the entire left instrument panel top panel has been fully reinstalled.
RELATED INFORMATION:
"Heater Fan and Core Installation" on page 7-4
"Canopy Removal" on page 11-3
"Canopy Installation" on page 11-4
"Nose Landing Gear (NLG) Leg Assembly Installation" on page 14-62
"Install Landing and Taxi Lights" on page 6-60
8.2.12 Instrument Panel Center Spine Removal and Installation
Use the following procedure to remove and install the instrument panel center spine.
TASK INFORMATION:
Type of Maintenance
Line
Level of Certification
LSA-RM
Task Specific Training Required
No
Special Tools Required
None
Parts Required
ME000557-B PAINTED, HANDHOLD, CENTER IP
8C50MTT3 SCREW, MACH TRH, 6LOBE, CRES, 8-32X.500
Aircraft System and Number
05—Equipment and Furnishings
Consumables
None
TASK INSTRUCTIONS:
1. Remove left instrument panel top panel. (See “Left Instrument Panel Top Panel Removal” on
page 8-19.)