ICON A5 - Seat Belt Inertia Reel Installation

3-40 INSPECTIONS / GENERAL INSPECTION TASKS
ICON A5 / MAINTENANCE MANUAL CHANGE C2
CHAPTER 3
None
Parts Required
None
Aircraft System and Number
NA
Consumables
None
TASK INSTRUCTIONS:
1. Remove the seat belt reel cover by pulling on each corner to release retaining clips.
2. Use a 3/8 wrench to remove the 5/16-24 locknut and washer securing the seatbelt reel to the
fuselage (for easier access to nut, pull seatbelt all the way out).
3. Remove the inertia reel.
VERIFICATION METHOD:
The procedure is complete when the seat belt inertia reel has been completely removed.
RELATED INFORMATION:
"Baggage Sidewall Panel Removal" on page 3-43
"Rigging Roll Controls" on page 9-20
"Inspect Roll Cable Tension" on page 9-13
"Rigging Yaw Controls" on page 9-87
"Rigging Pitch Controls" on page 9-46
3.6.2.4 Seat Belt Inertia Reel Installation
Uses this task to install the seat belt inertia reel.
TASK INFORMATION:
Type of Maintenance
Line
Level of Certification
LSA-RM
Task Specific Training Required
No
Special Tools Required
None
Parts Required