ICON A5 - Maintenance Schedules; Interval Maintenance-Operational Hours; Interval Maintenance-Calendar Intervals

3-4 INSPECTIONS / MAINTENANCE SCHEDULES
ICON A5 / MAINTENANCE MANUAL CHANGE C2
CHAPTER 3
3.2 Maintenance Schedules
The A5 has various components and systems that require periodic inspections, maintenance, or over-
haul. The maintenance schedules listed in the Related Information below summarize the required work
by calendar time and operational hours.
RELATED INFORMATION:
"Introduction" on page 3-3
"Interval Maintenance—Operational Hours" on page 3-4
"Interval Maintenance—Calendar Intervals" on page 3-5
"Overhaul Maintenance" on page 3-8
3.2.1 Interval Maintenance—Operational Hours
The inspections in the table below must be completed at the hour intervals listed. Maintenance is
completed at every 50, 100, etc. hours of flight, unless noted.
Interval (Flight Hours)
Inspection
Item
Maintenance
Initial
25
50 100 200 500 1000 Initials
Engine Condition and
100-Hour
Inspection (See
“Condition
Inspections and
100-Hour
Inspections” on
page 3-9.)
X
1
Or
every
12 mo.
Engine Engine Line
Maintenance (see
Rotax Manual)
XX XX
Engine Spark Plugs
Remove and
Replace (See
“General Engine
Line Maintenance”
on page 16-26.)
X
NOTE: If using leaded fuel (e.g. AVGAS) more than 30% of the time, See “Condition Inspections and
100-Hour Inspections” on page 3-9.