ICON A5 - Page 57

INSPECTIONS / MAINTENANCE SCHEDULES 3-5
CHANGE C2 ICON A5 / MAINTENANCE MANUAL
CHAPTER 3
Maintenance Comments:
|
|
|
|
|
RELATED INFORMATION:
"Maintenance Schedules" on page 2-16
"Condition Inspections and 100-Hour Inspections" on page 3-9
"General Engine Line Maintenance" on page 16-26
3.2.2 Interval Maintenance—Calendar Intervals
The inspections in the table below must be completed at calendar intervals. Maintenance timing
restarts for each item at the last completion. For example, the 2-year maintenance is to be completed
every two years.
Engine Oil Change if using
leaded fuel (i.e.
AvGas more than
30% of the time).
(See “Engine Oil
Check and
Replenish” on page
16-77.)
X
NOTE: If using primarily MoGas, See “Condition Inspections and 100-Hour Inspections” on page 3-9.
Engine Check/Clean Oil
Tan k
(See “General
Engine Line
Maintenance” on
page 16-26.)
X
NOTE: If using leaded fuel (e.g. AVGAS) more than 30% of the time, See “Condition Inspections and
100-Hour Inspections” on page 3-9.
1. The same inspection (See “Condition Inspections and 100-Hour Inspections” on page 3-9.) is required every 100 flight hours or every 12
calendar months, dependent on which comes first. On completion of the condition inspection or 100-hr inspection both the operation
hours and calendar time are reset.
Interval (Flight Hours)
Inspection
Item
Maintenance
Initial
25
50 100 200 500 1000 Initials