ICON A5 - Page 701

PROPULSION / ENGINE 16-77
CHANGE C2 ICON A5 / MAINTENANCE MANUAL
CHAPTER 16
6. Fill the engine with correct quantity and type of oil. (See “Engine Oil Check and Replenish” on
page 16-77.)
7. Purge the engine oil system per the latest Rotax 912iS Maintenance Manual.
8. Install top engine cowl. (See “Install Engine Cowlings” on page 16-16.)
VERIFICATION METHOD:
Complete the engine test run. (See “Engine Test Run” on page 16-7.)
RELATED INFORMATION:
"Inspect Engine Mount" on page 16-30
"General Engine Line Maintenance" on page 16-26
"Engine Removal" on page 16-19
"Remove Oil Tank" on page 16-72
16.1.8.3.3 Engine Oil Check and Replenish
Check and replenish the engine lubrication system
TASK INFORMATION:
Type of Maintenance
Line
Level of Certification
Owner/Pilot
Task Specific Training Required
No
Special Tools Required
None
Parts Required
Oil for replenishing oil system. Oil used must comply with approved engine oils and capacity.
Aircraft System and Number
13—Propulsion
Consumables
None
See A5-specific directions regarding checking and changing the oil. (See “A5 Specific Oil Change
Procedures” on page 16-78.)
TASK INSTRUCTIONS:
1. Open oil tank access door on the engine cowling and remove the oil tank cap.