PROPULSION / ENGINE 16-19
CHANGE C2 ICON A5 / MAINTENANCE MANUAL
RELATED INFORMATION:
"Inspect Engine Mount" on page 16-30
"Oil Cooler and Radiator Condition Inspection" on page 16-55
"Inspect Throttle Control for Proper Travel and Security" on page 16-32
"General Engine Line Maintenance" on page 16-26
"Install Engine" on page 16-21
"Engine Removal" on page 16-19
"Coolant Overflow Bottle Removal" on page 16-61
"Coolant Overflow Bottle Installation" on page 16-62
"Engine Coolant Replacement" on page 16-57
"Balance Propeller" on page 16-95
"ELT Transponder and Transmitter Antenna Assembly" on page 13-55
16.1.4.3 Engine Removal
This task should be used to safely remove the Rotax 912iS from the aircraft.
TASK INFORMATION:
Type of Maintenance
Heavy
Level of Certification
LSA-RM
Task Specific Training Required
No
Specific Tools Required
ITL-902 Engine Hoist End Effector
Parts Required
None
Aircraft System and Number
13—Propulsion
Consumables
None
1. Disconnect all electrical connections to ship’s battery ground terminal.
2. Remove entire cowling. (See “Remove Engine Cowlings” on page 16-13.)
NOTE: If desired, take photos to ensure proper routing of systems on
engine re-installation.
3. Disconnect signal and ground wires at starter solenoid.
4. Disconnect AAPTS sensor connector (near induction air filter).
To Next Page
Loading...
