ICON A5 - Page 719

PROPULSION / PROPELLER 16-95
CHANGE C2 ICON A5 / MAINTENANCE MANUAL
CHAPTER 16
Task Specific Training Required
No
Special Tools Required
Calibrated Torque Wrench
Parts Required
None
Aircraft System and Number
13—Propulsion
Consumables
None
TASK INSTRUCTIONS:
1. Inspect propeller per ‘ANNUAL INSPECTION’ task in the latest revision of Sensenich Propellers
document 3B0R5.
VERIFICATION METHOD:
Verify that the propeller is acceptable to each check specified and check off on the condition inspec-
tion listing.
RELATED INFORMATION:
"Condition and 100-Hour Inspection—Engine and Propeller" on page 3-21
16.2.4.2 Balance Propeller
Use the following procedure to balance the propeller.
TASK INFORMATION:
Type of Maintenance
Line
Level of Certification
LSA-RM
Task Specific Training Required
No
Special Tools Required
Propeller Balance System (such as ProBalancer Sport or DynaVibe GX3)
Parts Required
10F75MTT3-50TL (SCREW, MACH TH, 6LOBE, CRES, 10-32X.750X.500)
10F87M773/50TL (SCREW, MACH TH, 6LOBE, CRES, 10-32X.875)