ICON A5 - Page 14

1-10 REVISIONS / RECORD OF MAINTENANCE MANUAL REVISIONS
ICON A5 / MAINTENANCE MANUAL CHANGE C3
CHAPTER 1
• Updated task specific training in Use of VHB Tape for Installations and Repairs
Chapter 7
• References to torque stripe deleted from manual
Chapter 8
• Added Center Console Bucket procedure
• Added Throttle Handle and Bezel procedure
Chapter 9
• Added Measure Pitch Trim Tab Wear procedure
• Added Aileron Cable Tension Check
• Added Elevator Cable Tension Check
• Added Rudder Cable Tension Check
Chapter 11
• Updated Check Rudder Rigging
• Added Rudder Rigging procedure
• Added Elevator Rigging procedure
• Changed Complete Aircraft Parachute to ICON Parachute System (IPS)
Chapter 12
• Added Measure Horizontal Tail Tip Anti Rotation Pin Wear procedure
Chapter 14
• Wheel and Brake System Maintenance updated
• Update task specific training in Nose Landing Gear Actuator Replacement
Chapter 16
• Updated Engine Mount Installation and Removal
• Added Spinner Dome removal and installation
• Updated Engine Coolant Replacement
Chapter 17
• Replace wording of “wing lock cross pins” with “wing locking pins”
• Updated Flap Hinge Repair
• Updated task specific training in Aileron Cable Maintenance and Tensioning
• Change title of Aileron Cable Maintenance and Tensioning to Aileron Rigging