17-14 WING / WING GENERAL MAINTENANCE
ICON A5 / MAINTENANCE MANUAL CHANGE C2
Task Specific Training Required
No
Special Tools Required
A second person and a ladder are needed to hold the wing.
Parts Required
None
Aircraft System and Number
14—Wing
Consumables
None
See the instructions for removal of the left wing for helpful illustrations. The left wing has more systems
(AOA, fuel tank vent) passing through the universal joint hinge.
1. Unlock the wing locking mechanism by pressing the latch pawl on the wing lock switch, the simul-
taneously pull the wing handle lock down all the way to unlock both locking pins.
2. Pull the wing outward about a foot and rest securely on a ladder.
3. Locate the rotating pins in the rotating hinge joint and then remove the locking clips and pins.
4. Located inside the U-joint hinge is the electrical harness. Disconnect the electrical connector
from the protruding pigtail.
5. With the second person, remove the entire wing assembly from the fuselage.
VERIFICATION METHOD:
When wing is successfully removed from the airplane, this task is complete.
17.3.5 Install Right Wing
Instructions for installing the right wing onto the airplane.
TASK INFORMATION:
Type of Maintenance
Line
Level of Certification
LSA-RM
Task Specific Training Required
No
Special Tools Required
To Next Page
Loading...
