Intel Cyclone 10 GX User Manual

4. Perform a read-modify-write to address x00C[7:0] with the following bits: 8’b - - -
- - - - 1
5. Perform a read-modify-write to address x13F[7:0] with the following bits: 8’b - - -
- 1110
6. Perform the necessary steps from steps 9 to 12 in Steps to Perform Dynamic
Reconfiguration.
Note: A dash (-) indicates that the corresponding bit value should not be modified
Use the PRBS soft accumulators to count the number of accumulated bits and errors
when the hard PRBS blocks are used. For more details about using the accumulators
and reading the error values, refer to the "PRBS Soft Accumulators" section.
Related Information
• PRBS Soft Accumulators on page 357
• Steps to Perform Dynamic Reconfiguration on page 328
6.16.1.4. Enabling the PRBS Checker in bonded designs
You must perform a sequence of read-modify-writes to addresses 0x00A, 0x00B,
0x00C, 0x13F, 0x111 and to enable the PRBS data checker in bonded designs. To
enable the PRBS checker, follow these steps:
1. Perform the necessary steps from steps 1 to 7 in Steps to Perform Dynamic
Reconfiguration.
2. Perform a read-modify-write to address 0x00A with a value of 1'b1 to bit[7].
3. Perform a read-modify-write to address 0x00B according to Register Map for PRBS
Checker for bonded and non bonded designs.
4. Perform a read-modify-write to address 0x00C according to Register Map for PRBS
Checker for bonded and non bonded designs.
5. Perform a read-modify-write to address 0x13F according to Register Map for PRBS
Checker for bonded and non bonded designs.
6. Perform a read-modify-write to address 0x111 according to Register Map for PRBS
Checker for bonded and non bonded designs.
7. Perform the necessary steps from steps 9 to 12 in Steps to Perform Dynamic
Reconfiguration.
To disable the PRBS verifier write the original values back into the read-modify-
write addresses listed above.
6.16.1.5. Disabling/Enabling PRBS Pattern Inversion
The default PRBS pattern is inverted for both PRBS generator and checker. You can
disable the pattern inversion for PRBS data leaving or entering the PRBS data pattern
generator and checker, respectively. Table 205 on page 368 shows the addresses and
bits to control the inversion of the PRBS generator or checker. To disable the PRBS
pattern inversion for the PRBS generator or checker, follow these steps:
6. Reconfiguration Interface and Dynamic Reconfiguration
UG-20070 | 2018.09.24
Send Feedback
Intel
®
Cyclone
®
10 GX Transceiver PHY User Guide
367

Intel Cyclone 10 GX Specifications

General

Brand	Intel
Model	Cyclone 10 GX
Category	Transceiver
Language	English