EasyManuals Logo

Intel Cyclone 10 GX User Manual

Intel Cyclone 10 GX
402 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #366 background imageLoading...
Page #366 background image
1. Perform the necessary steps from steps 1 to 7 in Steps to Perform Dynamic
Reconfiguration.
2. Perform a read-modify-write to address 0x00A with a value of 1'b1 to bit[7].
3. Perform a read-modify-write to address 0x00B according to Register Map for PRBS
Checker for bonded and non bonded designs.
4. Perform a read-modify-write to address 0x00C according to Register Map for PRBS
Checker for bonded and non bonded designs.
5. Perform a read-modify-write to address 0x13F according to Register Map for PRBS
Checker for bonded and non bonded designs.
6. Perform the necessary steps from steps 9 to 12 in Steps to Perform Dynamic
Reconfiguration.
To disable the PRBS verifier write the original values back into the read-modify-
write addresses listed above.
Related Information
Steps to Perform Dynamic Reconfiguration on page 328
6.16.1.3.1. Examples of Enabling the PRBS Data Checker
Example 9. Enabling the PRBS9 pattern checker in 10-bit mode
1. Perform the necessary steps from steps 1 to 7 in Steps to Perform Dynamic
Reconfiguration.
2. Perform a read-modify-write to address x00A[7:0] with the following bits: 8’b1- -
- - - - -
3. Perform a read-modify-write to address x00B[7:0] with the following bits: 8’b0010
00 - -
4. Perform a read-modify-write to address x00C[7:0] with the following bits: 8’b - - -
- 1 - - 0
5. Perform a read-modify-write to address x13F[7:0] with the following bits: 8’b - - -
- 0001
6. Perform the necessary steps from steps 9 to 12 in Steps to Perform Dynamic
Reconfiguration.
Note: A dash (-) indicates that the corresponding bit value should not be modified
Example 10. Enabling the PRBS31 pattern checker in 64-bit mode
1. Perform the necessary steps from steps 1 to 7 in Steps to Perform Dynamic
Reconfiguration.
2. Perform a read-modify-write to address x00A[7:0] with the following bits: 8’b1- -
- - - - -
3. Perform a read-modify-write to address x00B[7:0] with the following bits: 8’b0000
11 - -
6. Reconfiguration Interface and Dynamic Reconfiguration
UG-20070 | 2018.09.24
Intel
®
Cyclone
®
10 GX Transceiver PHY User Guide
Send Feedback
366

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Intel Cyclone 10 GX and is the answer not in the manual?

Intel Cyclone 10 GX Specifications

General IconGeneral
BrandIntel
ModelCyclone 10 GX
CategoryTransceiver
LanguageEnglish

Related product manuals