Registering Destinations (Recipients) for Network Scanning
3
IC-402 3-10
– To enter the IP address, touch [IP Address Input], and then enter
the value. If the value was incorrectly entered, press the [C] (clear)
key to erase the value, and then use the keypad to type in the cor-
rect value. To change an entered value, touch [←] and [→] to move
the cursor to the desired position, and then type in the desired val-
ue.
– If [IP Address Input] is touched after entering the host name, the
host name is cleared.
– If the IP address is entered first, then [Host Name Input] is touched,
the IP address that was entered is displayed in the text box.
– Enter the host name and file path using capital letters.
7 Touch [OK].
8 Touch [File Path] and type in the file path using the keyboard that ap-
pears on the screen.
9 Touch [OK].
10 Touch [←Back] or [Fwd.→].
11 Touch [User ID] and type in the user ID using the keyboard that appears
on the screen.
– In order to send scan data to a folder that can only be accessed by
user accounts belonging to the domain, the user ID must be en-
tered in either of the following formats.
1 user_ID>@<domain_name>
2 <domain_name>\<user_ID>
(Note: In format 2, use the backslash (\). If the slash (/) is used, the
data will not be sent correctly.)
12 Touch [OK].
13 Touch [Password] and type in the password using the keyboard that
appears on the screen.
To Next Page
Loading...
