Copier Network Functions
6
IC-402 6-40
6.12 Total Counter Report Setting
You can specify the total counter notification schedule and notification des-
tination.
The total counter notification settings are as follows:
To specify the total counter notification settings
1 In the Administrator Setting screen, touch [5 Network Setting]. (Refer to
page 1-17 for more details.)
2 In the Network Setting screen, touch [6 Detail Setting].
3 In the Detail Setting screen, touch [4 Total Counter Report Setting].
– In order to use this function, the E-Mail TX (SMTP) parameters must
be correctly specified. Refer to “E-Mail TX (SMTP) Parameters” on
page 6-20 for more details.
– If the “POP Before SMTP” setting is required, the settings for POP
e-mail reception must be specified correctly. For details, refer to “E-
Mail RX (POP) Settings” on page 6-28.
– If a status notification e-mail message was not received by the re-
cipient, for example, due to an incorrect e-mail address, a message
specifying the error is sent to the e-mail address specified with the
“Administrator Registration” parameter on the Administrator/Ma-
chine Setting screen in Administrator mode.
The Total Counter Report Setting screen appears.
Item Description
Set Schedule Specify the period for notifying the total counter. Two types
of notification schedules can be specified. For details on
specifying the setting, refer to “Schedule Setting” on
page 6-41.
Set notification addresses. Specify the e-mail address of the notification destination.
The schedule can also be specified per address. For details
on specifying the setting, refer to “Notification Address Set-
ting” on page 6-43.
Device Nickname Specify the model name that is included in the notification
e-mail. Use the keyboard that appears in the touch panel to
type in the model name (up to 20 characters).
[Send Now] button Touch to send the current total counter to the notification
destination.
To Next Page
Loading...
