Specifying Network Scanning Settings
5
IC-402 5-4
5.2 Entering the Image Controller Setup Screen
You can enter the controller settings from the controller operation panel that
is displayed on the copier operation panel. To configure the image controller
from the operation panel of the controller, display the setup screen on the
controller.
Displaying the Setup Screen
1 On the copier operation panel, touch [Utility/Counter] — [Controller De-
tails].
2 On the controller operation panel, touch [MENU].
3 Use the up and down keys to show [Run Setup].
4 Touch the key to the right of [Run Setup] to show [Continue to Setup?].
5 Touch the key to the right of [OK] to show the setup screen.
– Enter the password if a password has been specified.
The setup screen appears.
2
Note
For the current password, check with the administrator of the image con-
troller.
To Next Page
Loading...
