Specifying Network Scanning Settings
5
IC-402 5-2
5 Specifying Network Scanning Settings
5.1 Available Settings
Specify the following settings from the operation panel of the image control-
ler or the control panel of the copier.
For details on displaying the setup screen from the operation panel of the im-
age controller, refer to “Entering the Image Controller Setup Screen” on
page 5-4.
For details on displaying the Administrator Setting screen from the control
panel of the copier, refer to “To display the Administrator Setting screen” on
page 1-17.
Copier Control Panel Scan to
E-mail
Scan to FTP Save in
Mailbox
Scan to SMB
Administrator Mode: [Network Setting] — [E-Mail Setting] — [E-Mail TX (SMTP)]
E-Mail TX Setting (Allow) o ———
Administrator Mode: [Network Setting] — [SMB Setting]
SMB TX Setting (ON) — — — o
Administrator Mode: [Security Setting] — [Management Function Setting]
Network Function Setting
(Allow)
——o —
Image Controller
Operation Panel
Scan to
E-mail
Scan to FTP Save in
Mailbox
Scan to SMB
Setup Mode: [Server Setup]
Enable mailbox passwords — — o —
Clear Each Scan Job o — o —
Setup Mode: [Network Setup] — [Protocol Setup] — [TCP/IP Setup]
oooo
Setup Mode: [Network Setup] — [Service Setup] — [FTP Setup] — [Scan to FTP]
Enable Scan to FTP — o ——
Enable Proxy Setup — G ——
Proxy Server IP Address — G ——
Proxy Server Port Number — G ——
Proxy Server Timeout (sec) — G ——
Proxy Server user name — G ——
To Next Page
Loading...
Need help?
General
