Using PageScope Web Connection
7
IC-402 7-74
7.29 TCP Socket Setting
You can specify TCP socket settings.
The settings that can be specified are described below.
2
Reminder
When changing the TCP socket settings, be sure to turn the power of the
copier off, then on again.
When the copier is turned off, then on again, turn off the auxiliary power
button before turning off the main power switch. In addition, wait at least
10 seconds to turn the machine on after turning it off; otherwise, the ma-
chine may not function normally.
If a certificate is set to “Enable” from the copier, a page appears for spec-
ifying settings for “Port Number (SSL/TLS)”.
If “TCP Socket” is set to “OFF”, it may no longer be possible to use ap-
plications on some computers.
Item Description
TCP Socket Specify whether to use a TCP socket.
Port No. Display the port number (input range: 1 to 65535).
Use SSL/TLS Select to use SSL/TLS.
Port Number(SSL/TLS) Display the port number for SSL/TLS (input range: 1 to 65535).
TCP Socket(ASCII Mode) Specify whether to use a TCP socket in the ASCII mode.
Port Number(ASCII Mode) Display the port number (input range: 1 to 65535).