Specifying Network Scanning Settings
5
IC-402 5-13
5.8 Setting the Sender (From) Address
Follow the procedure described below to specify the e-mail address that ap-
pears in the sender (From) line of e-mail messages sent with the Scan to E-
Mail operation or as a URL notification.
To set the sender (from) address
1 Show the setup screen from the image controller operation panel.
2 Select [Network Setup] — [Service Setup] — [E-mail Setup] and enter
the following settings.
2
Note
The sender (From) address is Fiery Email User Name@Fiery Email Do-
main Name.
Item Description
[Fiery Email User Name] Specify the mail user name of the sender.
[Fiery Email Domain
Name]
Specify the mail server domain name to which the sender belongs.
To Next Page
Loading...
Need help?
General
