Scanning Documents
2
IC-402 2-6
2.3 Sending Data in an E-Mail Message (Scan to E-Mail)
Scan to E-Mail
The Scan to E-mail operation is used to send images scanned on this ma-
chine to an e-mail address as an attachment.
The methods described below are available for specifying the destination.
The methods can also be combined, for example, by selecting a group des-
tination, then adding other destinations through direct input.
Using Programs
“Program” refers to a set of destination addresses and scan settings that are
registered together. This feature is convenient for frequently scanning docu-
ments and sending data under the same conditions. The following procedure
describes how to send data by selecting a program that has been registered
in advance.
For details on registering programs, refer to “Registering Program Destina-
tions” on page 3-18.
1 Press the [Scan] key on the control panel.
The Scan mode screen appears.
Scan
To Next Page
Loading...
