Registering Destinations (Recipients) for Network Scanning
3
IC-402 3-14
6 Touch [User Box Name] and set the mailbox name.
– Check that the mailbox where the document is to be saved exists
on the hard disk of the image controller, and then correctly type in
the name of the mailbox.
– Correctly type in the mailbox name using uppercase and lowercase
letters.
7 Touch [OK].
8 Touch [Index] and touch the desired button.
– This specifies the characters used to index the destination.
– For destinations that are often used, specify [Main] at the same
time, and it will be easier to search.
– If the first character of the name is a letter, the first character is au-
tomatically registered as the indexing character.
– The registration cannot be completed unless a mailbox name is
specified for “Name” and “User Box Name”.
9 Touch [OK], and then touch [OK] in the next screen that appears.
The mailbox destination is registered.
!
Detail
To check the registered destination, touch the button for the destination,
and then touch [Check Setting].
To change the registered destination settings, touch the button for the
desired destination, and then touch [Edit].
To delete the registered destination, touch the button for the desired des-
tination, and then touch [Delete].
If “3 Network Function Setting” (displayed by touching [9 Security Set-
ting] on the Administrator Setting screen, then [7 Management Function
Setting]) is set to “Disable”, registered box destinations do not appear.
To Next Page
Loading...
