Registering Destinations (Recipients) for Network Scanning
3
IC-402 3-19
6 Touch [Destination].
– To select from registered destinations:
Check that [Select from Address Book] is selected, touch the but-
ton for the desired destination type, and then select the destina-
tions to be registered.
– To enter the destinations directly:
Touch [Direct Input], touch the button for the desired destination
type, and then enter the destination to be registered.
7 Touch [Close].
– To register scan settings, touch [Yes] beside “Scan Setting”. For
details on the scan settings, refer to “Specifying the Scan Settings”
on page 2-52.
– To register communication settings, touch [Yes] beside “Communi-
cation Setting”. Specify the file name for saving the file and e-mail
notification settings.
8 Touch [OK].
The program destination is registered.
2
Note
The registration cannot be completed unless a setting is specified for
“Name” and “Remote Destination”.
To cancel changes to the setting, touch [Cancel].
To quit specifying the Utility mode setting, touch [Exit] in the sub display
area or press the [Utility/Counter] key. Otherwise, cancel the Utility mode
by touching [Close] in each screen until the screen for the Copy, Fax,
Scan or Box mode appears.
!
Detail
For the procedure to enter characters, refer to “Entering Text” on
page 9-2.
To Next Page
Loading...
