Diagnostic aids 3-15
5026
To run the Quick Test (duplex):
1. Select Quick Test from DUPLEX TESTS, and press Select ().
2. Select Single or Continuous, and press Select ().
• The single Duplex Quick test cannot be canceled.
• The printer attempts to print the Quick Test Page from the default paper source.
• Check the Quick Test Page for the correct offset between the placement of the first scan line on the
front and back side of a duplexed sheet.
The single test stops automatically when a single duplex sheet is printed, and the continuous test continues until
you press Stop (
).
Print Test (duplex)
This test provides service personnel with a way to verify the function of the printer’s duplex hardware. After the
user selects this test, the device automatically executes a continuous print test that generates a duplexed, color
output page. To stop the test, the user must press Stop ( ). While this test executes, the power indicator light
blinks green and the panel displays “DUPLEX TESTS Printing...”.
The paper you choose to print the page on should be either Letter or A4.
To run the Print Test (duplex):
1. Select DUPLEX TEST in the Diagnostics Menu, and press Select ().
2. Select Print Test, and press Select ().
The printer executes a continuous print test that generates a duplexed, color output page.
3. To stop the test, press Stop ( ).
To Next Page
Loading...
Need help?
General
