4-28 Service Manual
5026
Operator panel bezel removal
See Operator panel bezel on page 7-3 for the part number.
1. Open the front cover.
2. Rotate the operator panel to its highest position.
3. Using a flathead screwdriver or similar tool, unsnap the locking tabs on the upper left and the upper right of
the bezel. The tabs on the right and left side will then release.
4. Rotate the bezel down, and remove the bezel.
Installation note: When reinstalling or replacing the bezel, insert the bottom of the bezel first, ensuring that the
bezel bottom portion fully seats.
To Next Page
Loading...
