Message Action
Replace defective black and color imaging
kit [31.xy]
Replace the defective imaging kit to clear the message and
continue printing. For more information, see the instruction
sheet that came with the supply.
Note: If you do not have a replacement imaging kit, then
see the "Ordering supplies" section of the User’s Guide or
visit
http://support.lexmark.com.
Replace jammed originals if restarting
job.
Try one or more of the following:
• Touch Cancel job to clear the message and cancel the scan
job.
• Touch Scan from automatic feeder to continue scanning
from the ADF immediately after the last successful scan
job.
• Touch Scan from flatbed to continue scanning from the
scanner immediately after the last successful scan job.
• Touch Finish job without further scanning to end the last
successful scan job.
• Touch Restart job to restart the scan job with the same
settings from the previous scan job.
Replace maintenance kit, 0 estimated
pages remain [80.xy]
Contact customer support at
http://support.lexmark.com or
your service representative, and then report the message. The
printer is scheduled for maintenance.
Replace missing [color] cartridge
[31.xy]
Install the indicated toner cartridge to clear the message. For
more information, see the “Replacing supplies” section of the
User’s Guide.
Replace missing black and color imaging
kit [31.xy]
Install the indicated imaging kit to clear the message. For more
information, see the “Replacing supplies” section of the User’s
Guide.
Replace waste toner bottle [82.xy]
Replace the waste toner bottle to clear the message.
Replace unsupported [color] cartridge
[32.xy]
Remove the toner cartridge, and then install a supported one
to clear the message.
Note: If you do not have a replacement cartridge, then see
the "Ordering supplies" section of the User’s Guide or visit
http://support.lexmark.com.
Replace unsupported black and color
imaging kit [32.xy]
Remove the indicated imaging kit, and then install a supported
one to clear the message.
Note: If you do not have a replacement imaging kit, then
see the "Ordering supplies" section of the User’s Guide or
visit
http://support.lexmark.com.
Replace missing waste toner bottle
[82.xy]
Install the missing waste toner bottle to clear the message.
For more information, see the instruction sheet that came
with the supply.
7527
Diagnostic information
84
To Next Page
Loading...
