August 13, 2014
• Blank display and noise (five beeps) symptoms were added. Blank display, five beeps service check topic was added
to address the symptoms.
• New error codes were added (126.06, 126.24, and 201.22).
• LVPS service check was revised.
• Controller board cooling fan service check was revised.
July 17, 2014
• Torque limiter was added to the ADF separator roller (40X7775) FRU.
• All instances of torque limiting clutch were renamed to torque limiter.
July 4, 2014
• The staple cartridge holder (40X7466) FRU was added to the Staple finisher option 2 and Staple, hole punch finisher
1 Parts catalog assemblies.
June 2, 2014
• Callout revisions were implemented for the Frame assembly table under Parts catalog.
June 2, 2014
• Callout revisions were implemented for the Frame assembly table under Parts catalog.
May 7, 2014
• A warning for turning off the printer prior to removal was added to the fuser removal topic.
February 28, 2014
• Added the Restoring solutions, licenses, and configuration settings topic under Removal precautions.
• Updated the Restoring the printer configuration after replacing the controller board topic.
• Changed PN 40X79653 to PN 40X9653 for the control panel in Assembly 9.
• Changed the title from eSF backup to Backing up eSF solutions and settings, and updated the topic.
• Updated the Controller board removal topic.
• Editorial changes
January 17, 2014
• Restore factory defaults topics were added to the service menus.
• Updating the printer firmware topics were added to the repair information.
• Updated the User attendance messages (0–99.99) table.
• Toner add error service check topic was added to the diagnostic information.
January 3, 2014
• Parts catalog FRU (40X9754—Transfer guide static brush) was added.
7463
Preface
38
To Next Page
Loading...
