December 18, 2013
• Added the following removal topics in the Repair information chapter:
– Control panel board and display removal (MX711)
– Control panel board and display removal (MX81x)
• Split the former Assembly 9: Control panel (MX71x and XM51xx) in the parts catalog into two assemblies:
– Control panel (MX710 and XM5163)
– Control panel (MX711 and XM5170)
• The following part numbers were changed in the parts catalog:
– 40X7860 to 40X9653 for the control panel (MX710)
– 40X7862 to 40X9236 for the control panel board (MX710)
– 40X7877 to 40X9246 for the control panel (MX711)
– 40X7771 to 40X9232 for the ADF controller card
– 40X7893 to 40X9233 for the controller board (MX710)
– 40X7936 to 40X9234 for the controller board (MX711, MX81x)
– 40X7882 to 40X9250 for the control panel assembly for MX81x
– 40X7765 to 40X9228 for the ADF assembly (MX710)
– 40X7799 to 40X9229 for the ADF assembly (MX711)
– 40X7748 to 40X9231 for the ADF assembly (MX81x)
• Added the following part numbers in the parts catalog:
– 40X9230 for the control panel board and display kit for MX711 (Wolrdwide except for European Union)
– 40X9245 for the control panel board and display kit for MX711 (European Union use only)
– 40X9238 for the control panel board and display kit for MX81x (Wolrdwide except for European Union)
– 40X9249 for the control panel board and display kit for MX81x (European Union use only)
October 23, 2013
• The following FRU numbers were revised:
– 40X8803 (replaced with 40X7683—Internal duplex with cable)
– 40X8804 (replaced with 40X7668—Duplex rear flap)
August 30, 2013
• The list of sensors supported for the Base sensor test was updated.
• Parts catalog assembly (Covers (MX81x and XM71xx) was updated.
August 22, 2013
• Topic for restoring the printer configuration after replacing the controller board was added.
• Additional procedure added for the installation note for the controller board removal topic.
• The following Option FRUs were included in the parts catalog:
Staple finisher option FRUs
– 40X8740—Media pusher assembly
– 40X8721—Stapler option latch
– 40X8739—Stapler main motor
7463
Preface
39
To Next Page
Loading...
