Lexmark MX71X - Page 42

– Staple, hole punch left cover removal
– Staple, hole punch right cover removal
– Sensor (cartridge door interlock) removal
– Stapler door close limit switch removal
– Stapler carriage assembly removal
– Sensor (throat media present) removal
– Staple, hole punch latch removal
– Stapler controller board removal
– Stapler main motor removal
– Stapler paddle motor removal
– Sensor (paddle motor HP) removal
– Stapler diverter motor removal
– Stapler diverter plunger assembly removal
– Stapler drive gear assembly removal
– Sensor (bin full send) removal
– Sensor (bin full receive) removal
– Staple, hole punch lower interface cable removal
– Media pusher assembly removal
– Standard output bin LED removal
– Sensor (finisher bin media present) removal
– Staple, hole punch top cover removal
– Sensor (right tamper motor HP) removal
– Sensor (left tamper motor HP) removal
– Stapler tamper assembly removal
– Tamper motor (right) removal
– Tamper motor (left) removal
– Tamper drive belt removal
– Stapler output bin LED removal
– Staple, hole punch tray link tension spring removal
– Staple, hole punch tray link removal
– Sensor (hole punch box present) removal
– Sensor (HPU rear door interlock) removal
Staple, hole punch finisher parts catalog
– Staple, hole punch finisher option 1
– Staple, hole punch finisher option 2
– Staple, hole punch finisher option 3
– Staple, hole punch finisher option 4
• The following topics were revised:
– 3xx error messages (300-399.99)
– 4xx error messages (400-499.99)
7463
Preface
42