Lexmark MX71X - Page 43

– Option tray symptoms
– Sensor (mailbox pass through) jam service check
– Mailbox diverter jam service check
– Sensor (finisher pass through) jam service check
– Finisher left tamper jam service check
– Finisher right tamper jam service check
– Finisher ejector jam service check
– Finisher diverter jam service check
– Finisher paddle jam service check
– Finisher tray holder jam service check
– Mailbox incorrect bin exit service check
– Finisher door undetected service check
– Stapler carriage failure service check
– Finisher bin media present error service check
– Output options
• Added Bin insert (40X8855) to Parts catalog Assembly 1 and 2.
May 15, 2013
• Updated the Transfer roll removal procedure.
• Updated the ADF elevator tray motor stalled error service check.
• Added installation note to the ADF assembly and the ADF controller card removal procedures.
April 25, 2013
• Added 176—Controller board cooling fan failure error code.
• Added Controller board cooling fan service check.
• Changed Miscellaneous cooling fan service check to Fuser cooling fan service check.
• Added Scanner tests to the Diagnostic menu subgroup.
• Updated ADF separator roll removal procedure.
• Updated Japan power cord part number.
• Deleted part numbers 40X8399 and 40X8401.
• Deleted duplicate and inapplicable entries in Miscellaneous parts catalog assembly.
• The following Option‑related topics were added:
Staple finisher option removals
– Sensor (throat media present) removal
– Stapler/offset stacker option latch removal
– Stapler/offset stacker tray spring removal
– Stapler/offset stacker tray link assembly removal
– Sensor (stapler/stacker rear door interlock) removal
– Sensor (paddle motor HP) removal
– Sensor (right tamper motor HP) removal
7463
Preface
43