Lexmark MX71X - Page 44

– Sensor (left tamper motor HP) removal
– Tamper assembly removal
– Stapler/offset stacker output bin LED removal
– Stapler/offset stacker main motor removal
– Stapler/offset stacker diverter motor removal
– Stapler/offset stacker diverter plunger assembly removal
– Stapler/offset stacker drive gear assembly removal
– Media pusher assembly removal
– Stapler/offset stacker feed roll removal
– Stapler/offset stacker chute assembly removal
– Sensor (stapler/stacker pass through) removal
– Stapler/offset stacker ejector motor assembly removal
– Sensor (stapler/stacker ejector HP) removal
– Sensor (media pusher HP) removal
Mailbox option removals
– Mailbox top bin cover with bail removal
– Mailbox option latch removal
– Sensor (mailbox rear door interlock) removal
– Sensor (mailbox diverter HP) removal
– Mailbox diverter plunger assembly removal
– Mailbox main drive gear removal
– Mailbox main motor removal
– Mailbox top diverter removal
– Mailbox middle diverter removal
– Mailbox top diverter spring removal
– Sensor (mailbox pass through) removal
February 13, 2013
• Added 31.66 and 250.08 error code descriptions.
• Added MPF solenoid removal procedure.
February 8, 2013
• 10.xx and 24x.08 errors were added to the User attendance messages table.
• 24x.08 errors were added to the 24x paper jams and Input option jam error messages tables.
• Added Scanner Calibration topics in the Repair information chapter.
• Updated procedures under ADF skew adjustments.
• Added to the Service menus chapter: Updating the printer firmware
• Updated service check: Sensor (ADF 1st scan) late leaving or not cleared jam
• Updated model numbers on Cover and General information.
7463
Preface
44