MacDon FlexDraper FD140 - Page 619

definition ..........................................................19
fingers
auger fingers ..................................................428
adjusting auger finger timing.........................435
checking finger timing ..................................434
installing .....................................................431
removing.....................................................429
plastic reel fingers
installing .....................................................510
removing.....................................................509
steel reel fingers
installing .....................................................508
removing.....................................................507
flex modes
operating in flex mode .......................................70
flighting.......................................................331, 428
float..................................................................... 64
header float
checking and adjusting... ................................64
header float locks..............................................69
wing float locks
unlocking ... ... .......................................... 70–71
float module .......................................................545
float modules
attaching float module to header ......................377
attaching/detaching.........................................372
auger drive
adjusting auger drive chain tension ...............423
augers............................................................419
auger fingers ...............................................428
adjusting auger finger timing .....................435
checking finger timing ...............................434
installing . ... ..............................................431
removing .................................................429
auger to pan clearance.................................419
optional FM100 feed auger flighting...............555
detaching from combine and header... ..............372
feed auger configurations ................................307
feed deck pan
lowering ......................................................479
raising.........................................................481
feed deflectors .........................................371, 482
replacing on New Holland CR combines ........ 483
feed draper.....................................................466
adjusting draper tension ...............................468
drive roller ..... ..............................................469
installing feed draper drive roller ................472
removing feed draper drive roller . ..............469
drive roller bearing
installing . ... ..............................................474
removing .................................................473
replacing..................................................473
idler roller....................................................475
installing . ... ..............................................476
removing .................................................475
idler roller bearing
replacing..................................................477
replacing feed draper ...................................466
flighting . ..................................................331, 428
setup..............................................................331
stripper bars .. .................................................482
installing .....................................................483
kits .............................................................331
removing.....................................................482
unplugging .....................................................289
FM100 dual AHHC sensor ..................................555
FM100 feed auger flighting..................................555
FM100 float modules
component identification ...... .............................. 26
G
gearboxes
adjusting drive chain tension ............................418
header drive
adding oil ....................................................405
changing oil.................................................405
checking oil level .........................................404
lubricating ...................................................404
Gleaner combines
attaching header to combine ............................340
auger configurations.................................307, 310
detaching combine from header .......................345
replacing reel speed sensors ...........................538
glossary...............................................................19
greasing
every 100 hours ..............................................393
every 25 hours ................................................390
every 250 hours ..............................................396
every 50 hours ................................................391
every 500 hours ..............................................397
greasing procedure .........................................399
maintenance schedule/records ........................385
ground speeds .....................................................90
GSL
definition ..........................................................19
guards...............................................................441
See also hold-downs
knife guards....................................................441
adjusting knife guards ...... ............................441
replacing pointed guards ..............................443
replacing stub guards...................................446
stub guard conversion kit .................................550
GVW
definition ..........................................................19
INDEX