Mazda 6 2002 - Diagnostic Monitoring Test Results

ON-BOARD DIAGNOSTIC
F65
F
For MTX
For ATX
5. Stop vehicle and access to ON BOARD SYSTEM
READINESS menu of GENERIC OBD
FUNCTION to inspect the Drive Mode completion
condition. If completed, RFC changes from NO to
YES.
6. If not completed, turn the ignition key to OFF,
then go back to Step 4.
7. Access DIAGNOSTIC MONITORING TEST RESULTS menu of GENERIC OBD FUNCTIONS to inspect the
monitor results. If MEAS are not within the specification, repair has not completed.
8. Verify no DTC is available.
End Of Sie
DIAGNOSTIC MONITORING TEST RESULTS
A6E397018881W10
• The purpose of this test mode is to confirm the result of OBD monitor diagnostic test results. The result values
stored when particular monitor is completed are displayed. If the monitor is not completed, initial value is
displayed.
End Of Sie
Zone
Shift
Position
Vehicle Speed
km/h {mph}
Time
Sec.
O Neutral 0 {0} T1: Above 455
A 2nd 4050 {2532}
T2: Above 30
B 3rd 6575 {4147}
C 2nd 6075 {3846}
T3: Above 20
D 3rd 75100 {4762}
E 4th 5075 {3146}
T4: Above 120
F 5th 75100 {4762}
A6E3970W004
Zone Range
Vehicle Speed
km/h {mph}
Time
Sec.
O P or N 0 {0}
T1: Above
455
A S (HOLD) 4065 {2541}
T2: Above 30
B D (HOLD) 65100 {4062}
C S (HOLD) 6075 {3846}
T3: Above 20
D D (HOLD) 85100 {5262}
E D (HOLD) 5075 {3147}
T4: Above
120
F D 75100 {4662}
A6E3970W005
TEST ID Description Related system
10:01:0A Rich to lean sensor threshold voltage
HO2S
10:02:0A Lean to rich sensor threshold voltage
10:03:0A Low sensor voltage for switching time calculation
10:04:0A High sensor voltage for switching time calculation
10:05:10 Rich to lean sensor switching time
10:06:10 Lean to rich sensor switching time
10:0A:10 Sensor period
10:80:20 Front and rear HO2S switching time ratio TWC