P12
CONVENTIONAL BRAKE SYSTEM
6. Install the master cylinder to the power brake unit.
Caution
•
••
• If after installing the master cylinder, air
does not bleed properly from the brake
lines even after performing air bleeding,
brake drag occurs or other
characteristics are present, it is possible
that the master cylinder piston is jammed
against the power brake unit. If air cannot
be bled properly, brake drag exists or
other malfunctions occur, remove the
master cylinder and reinstall properly.
End Of Si e
FLUID LEVEL SENSOR INSPECTION
A6E691243540W01
1. Disconnect the negative battery cable.
2. Disconnect the sensor connector.
3. Inspect for continuity between terminals of fluid level sensor.
• If not as specified, replace the fluid level sensor.
End Of Sie
MASTER CYLINDER DISASSEMBLY/ASSEMBLY
A6E691243400W02
Caution
•
••
• If the master cylinder body is damaged, replace the unit as a component. When securing the
master cylinder in a vise, tighten only the flange of the master cylinder.
1. Disassemble in the order indicated in the table.
2. Assemble in the reverse order of disassembly.
.
A6E6912W032
A6E6912W024
A6E6912W023
A6E6912W019
1 Cap set 2Screw
To Next Page
Loading...
