Mazda 6 2002 - Front Beltline Molding Removal; Front Beltline Molding Installation

MOLDING
S55
S
FRONT BELTLINE MOLDING REMOVAL
A6E773050640W01
Note
• When removing the front beltline molding, the clip may be damaged. If the clip is damaged, replace it with
a new one.
1. Pull the A section upward and remove the clip.
2. Rotate the B section of the front beltline molding
in direction (2), along the direction (1) shown in
the figure and remove it from the body.
End Of Sie
FRONT BELTLINE MOLDING INSTALLATION
A6E773050640W02
1. Press the clip into the body.
2. Press in the B section of the front beltline molding
along the direction (1) shown in the figure to
attach it to the body.
Note
• If the front beltline molding is difficult to
attach, apply soapy water.
End Of Sie
MOLDING
A6E7730W001
A6E7730W003