Mazda 6 2002 - Steering Angle Sensor Inspection; Dsc off Switch; Dsc off Switch Inspection

P44
DYNAMIC STABILITY CONTROL
2) Measure voltage at output terminal D and
ground terminal E when the yaw rate
sensor is rotated left and right.
Caution
•
••
• Be careful when turning the yaw rate
sensor rotation position while it is in a
reversed state because the rotation
direction and voltage will be reversed.
Voltage
Right rotation:
fluctuation between 2.54.62 V
Left rotation:
fluctuation between 2.50.33 V
End Of Si e
COMBINE SENSOR INITIALIZATION PROCEDURE
A6E692067650W07
1. Set the SST (WDS or equivalent) to the DLC-2
2. Access the active command mode and select the
YAWRATE, then follow the indication on the
monitor.
3. Select the LATACCEL and follow the indication
on the monitor.
End Of Si e
STEERING ANGLE SENSOR REMOVAL/INSTALLATION
A6E692067650W08
1. (See T38 COMBINATION SWITCH DISASSEMBLY/ASSEMBLY.)
End Of Si e
STEERING ANGLE SENSOR INSPECTION
A6E692067650W09
1. (See T39 STEERING ANGLE SENSOR INSPECTION.)
End Of Si e
DSC OFF SWITCH REMOVAL/INSTALLATION
A6E692067650W10
1. (See P31 TCS (DSC) OFF SWITCH REMOVAL/INSTALLATION.)
End Of Si e
DSC OFF SWITCH INSPECTION
A6E692067650W11
1. (See P32 TCS (DSC) OFF SWITCH INSPECTION.)
End Of Si e
A6E6920W005
A6E3970W002