EasyManua.ls Logo

Mazda 6 2002 - Pre-Delivery Inspection

Mazda 6 2002
1187 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
GI32
PRE-DELIVERY INSPECTION
PRE-DELIVERY INSPECTION
A6E203200012W01
PRE-DELIVERY INSPECTION TABLE
EXTERIOR
• INSPECT and ADJUST, if necessary, the
following items to specification:
❏Glass, exterior bright metal and paint for damage
❏All weatherstrips for damage or detachment
❏Door operation and alignment including side door
and back door
❏Wheel lug nuts
❏Tire pressures
❏Headlight aiming
❏Headlight cleaner and fluid level (if equipped)
❏Operation of bonnet release and lock
❏Operation of liftgate and fuel lid opener
• INSTALL the following parts:
❏Flap (front and rear)
❏Wheel caps or rings (if equipped)
UNDER BONNETENGINE OFF
• INSPECT and ADJUST, if necessary, the
following items to specification:
❏Fuel, engine coolant, and hydraulic lines, fittings,
connections, and components for leaks
❏Accelerator cable and linkage for free movement
❏Tension of drive belts
❏Tightness of water hose clamps
❏Tightness of battery terminals, electrolyte level and
specific gravity
❏Radiator coolant level and specific gravity
❏Engine oil level
❏Oil level in steering gearbox
❏Windshield washer tank fluid level
❏Brake master cylinder fluid level
❏Clutch master cylinder fluid level (MTX only)
❏Power steering fluid level
❏Manual transaxle oil level (MTX only)
CLEAN the spark plugs
INTERIOR
• INSTALL the following parts:
❏Fuse for accessories
• CHECK the operations of the following items:
❏All lights including warning, and indicator lights
❏Cigarette lighter and clock
❏Ignition switch and steering lock
❏Transaxle range switch (ATX only)
❏Warning buzzers
❏Seat belts warning system
❏Ignition key reminder alarm
❏Seat controls (sliding and reclining) and headrests
❏Seat belt warning system
❏Door locks, including childproof door locks
❏Power door lock
❏Power windows (if equipped)
❏Horn, wipers, and washers
❏Wiper blades performance
Clean the wiper blades and windshield, if necessary
❏Antenna
• CHECK the following items:
❏Presence of spare fuse
❏Upholstery and interior finish
• CHECK and ADJUST, if necessary, the following
items:
❏Operation and fit of windows
❏Parking brake
❏Pedal height and free play of brake pedal
UNDER BONNETENGINE RUNNING AT
OPERATING TEMPERATURE
• CHECK the following items:
❏Operation of idle-up system for electrical load, air
conditioner
❏Idle speed
❏Automatic transaxle fluid level (ATX only)
❏Initial ignition timing
❏Operation of throttle position sensor
❏Operation of EGR valve
ON HOIST
• CHECK the following items:
❏Underside fuel, coolant and hydraulic lines, fittings,
connections, and components for leaks
❏Tires for cuts or bruises
❏Steering linkage, suspension, exhaust system, and
all underside hardware for looseness or damage
ROAD TEST
• CHECK the following items:
❏Brake operation
❏Clutch operation
❏Steering control
❏Operation of meters and gauges, squeaks, rattles,
and abnormal noises
❏Engine general performance
❏Emergency locking retractors
AFTER ROAD TEST
• REMOVE the seat and floor mat protective covers
CHECK for the necessary owner information
materials, tools, and spare tire in vehicle
End Of Sie
PRE-DELIVERY INSPECTION

Table of Contents