Mazda 6 2002 - Parking Brake System; Parking Brake (Lever Type); Parking Brake (Lever Type) Removal;Installation

P26
PARKING BRAKE SYSTEM
PARKING BRAKE (LEVER TYPE) INSPECTION
A6E691444000W01
1. Pull the parking brake lever a few times.
2. Depress the brake pedal a few times.
3. Inspect the parking brake stroke by pulling the parking brake lever with a force of 98 N {10 kgf, 22 lbf}.
Stroke
36 notches
End Of Sie
PARKING BRAKE (LEVER TYPE) ADJUSTMENT
A6E691444000W02
1. Start the engine and depress the brake pedal several times.
2. Stop the engine.
3. Remove the ashtray behind the center console.
4. Turn the adjusting nut as shown in the figure.
5. After adjustment, inspect the following points:
(1) Turn the ignition switch to ON, pull the parking
brake lever one notch, and verify that the
parking brake warning light illuminates.
(2) Verify that the rear brakes do not drag.
End Of Sie
PARKING BRAKE (LEVER TYPE) REMOVAL/INSTALLATION
A6E691444000W03
1. Remove the center console. (See S86 CONSOLE REMOVAL/INSTALLATION.)
2. Remove the rear seat cushion (4SD) or rear seat (5HB) . (See S110 REAR SEAT REMOVAL/
INSTALLATION.)
3. Remove the exhaust pipe bracket.
4. Remove in the order indicated in the table.
5. Install in the reverse order of removal.
6. Adjust the parking brake stroke. (See P26 PARKING BRAKE (LEVER TYPE) ADJUSTMENT.)
.
End Of Sie
PARKING BRAKE SYSTEM
A6E6914W002
A6E6914W001
1 Parking brake switch
2 Adjusting nut
3 Parking brake lever
4Clip
5 Parking brake cable