Mazda 6 2002 - Front Stabilizer; Stabilizer Control Link

R22
FRONT SUSPENSION
FRONT STABILIZER REMOVAL/INSTALLATION
1. Remove the front crossmember component. (See R23 FRONT CROSSMEMBER REMOVAL/
INSTALLATION.)
2. Remove in the order indicated in the table.
3. Install in the reverse order of removal.
4. Adjust the headlight zeroset.
(See T31 HEADLIGHT ZEROSET.)
5. Inspect the front wheel alignment.
(See R5 FRONT WHEEL ALIGNMENT.)
.
Stabilizer Bracket Installation Note
1. Apply rubber grease to the inside surface of the stabilizer bushing.
2. Align the bushing with the inside of positioning plate on the stabilizer bar.
3. Install the stabilizer bracket.
End Of Sie
1 Stabilizer control link
2 Stabilizer bracket
(See R22 Stabilizer Bracket Installation Note)
3 Stabilizer bushing
4 Front stabilizer
A6E7414W020
A6E7414W015