Mazda 6 2002 - Thermostat Inspection; Water Pump; Water Pump Removal;Installation

E8
THERMOSTAT, WATER PUMP
THERMOSTAT INSPECTION
A6E361815171W02
1. Inspect the thermostat for the following.
• Closed valve in room temperature
• Opening temperature and lift of the valve
 If not as specified, replace the thermostat.
End Of Sie
WATER PUMP REMOVAL/INSTALLATION
A6E362015010W01
1. Disconnect the negative battery cable.
2. Drain the engine coolant. (See E3 COOLING SYSTEM SERVICE WARNINGS.) (See E3 ENGINE
COOLANT REPLACEMENT.)
3. Loosen the water pump pulley bolt to remove the drive belt. (See B3 DRIVE BELT REPLACEMENT.)
4. Remove in the order indicated in the table.
5. Install in the reverse order of removal.
6. Refill the engine coolant. (See E3 ENGINE COOLANT REPLACEMENT.)
7. Inspect the engine coolant leakage. (See E4 ENGINE COOLANT LEAKAGE INSPECTION.)
Initial-opening temperature
80.084.0 {176183.2}
(°C {°F})
Full-open temperature
97 {206.6}
(°C {°F})
Full-open lift (mm {in}) More than 8.0 {0.31}
WATER PUMP
AME3620W001
1 Water pump pulley
2 Water pump