Mazda 6 2002 - Headlight Cleaner Hose Removal;Installation; Headlight Cleaner Switch Inspection; Headlight Cleaner Switch Removal;Installation

WIPER AND WASHER
T71
T
HEADLIGHT CLEANER HOSE REMOVAL/INSTALLATION
A6E811651030W06
1. Remove the front bumper. (See S47 FRONT BUMPER REMOVAL/INSTALLATION)
2. Remove in the order indicated in the table.
3. Install in the reverse order of removal.
End Of Sie
HEADLIGHT CLEANER SWITCH REMOVAL/INSTALLATION
A6E811651030W07
1. Disconnect the negative battery cable.
2. Remove in the order indicated in the table.
3. Install in the reverse order of removal.
Headlight Cleaner Switch Removal Note
1. Insert your hand from the lower side of the dashboard and squeeze the tabs of the headlight cleaner switch.
2. Pull the headlight cleaner switch forward to remove it.
End Of Sie
HEADLIGHT CLEANER SWITCH INSPECTION
A6E811651030W08
1. Disconnect the negative battery cable.
2. Remove the headlight cleaner switch. (See T71 HEADLIGHT CLEANER SWITCH REMOVAL/
INSTALLATION)
3. Inspect for continuity between the headlight
cleaner switch terminals using an ohmmeter.
• If not as specified, replace the light switch.
End Of Sie
1Clip
2 Headlight cleaner hose
3Check valve
A6E8116W118
1 Headlight cleaner switch (See T71 Headlight
Cleaner Switch Removal Note)
2 Connector
A6E8116W125
A6E8116W138
A6E8116W139