Mazda 6 2002 - Windshield Installation

WINDOW GLASS
S65
S
2. Pass the SST (piano wire) through the hole.
Warning
•
••
• Using a SST (piano wire) with bare hands
can cause injury. Always wear gloves
when using a SST (piano wire).
3. Wind each end of the SST (piano wire) around a
bar.
Note
• Use a long sawing action to spread the work
over the whole length of the SST (piano
wire) to prevent it from breaking.
4. Working with another person, saw through the
sealant around the edge of the glass.
5. Remove the windshield.
6. Remove the pins from the windshield.
7. Remove the winshield molding from the
windshield glass.
End Of Sie
WINDSHIELD INSTALLATION
A6E773863900W02
Caution
•
••
• To prevent the sealant from cracking or the glass from being pushed out by air pressure if a door
is closed, open all of the windows and leave them open until the sealant has hardened.
1. Cut away the old sealant using a razor so that 12 mm {0.040.07 in} thickness of sealant remains around
the circumference of the frame.
Warning
•
••
• Using a razor with bare hands can cause injury. Always wear gloves when using a razor.
2. If the sealant has come off completely in any one
place, apply some primer after degreasing, and
allow it approximately 30 minutes to dry. Then
put on new sealant to create a 2 mm {0.08 in}
layer.
3. Clean and degrease an approximately 50.0 mm
{1.97 in} wide strip around the circumference of
the glass and the bonding area on the body.
A6E7738W008
A6E7738W021
A6E7738W023