Mazda 6 2002 - Page 396

K22
AUTOMATIC TRANSAXLE
3. Disconnect the cord assembly connector.
4. Verify that there is no continuity between cord
assembly terminal and ground.
• If as continuity, inspect the cord assembly.
• If the cord assembly is okay, inspect the oil
pressure switch. (See K22 On-vehicle
Inspection (oil pressure switch inspection).)
5. Connect the cord assembly connector.
6. Install the under cover.
7. Connect the negative battery cable.
On-vehicle Inspection (oil pressure switch inspection)
1. Remove the under cover.
2. Disconnect the cord assembly connector.
3. Start the engine, with gear position in N or P.
4. Reaffirm that there is no continuity between cord
assembly terminal and ground.
5. Firmly depress the brake pedal with the left foot.
6. Shift the selector lever to D range.
7. Verify that there is no continuity between cord
assembly terminal and ground.
• If not as specified,replace the oil pressure
switch. (See K23 OIL PRESSURE SWITCH
REMOVAL/INSTALLATION.)
8. Connect the oil pressure switch connector.
9. Install the under cover.
10. Connect the negative battery cable.
A6E5614W026
A6E5614W027
A6E5614W026
A6E5614W094