Mazda 6 2002 - Page 414

K40
AUTOMATIC TRANSAXLE
WITHOUT OIL COOLER
.
Radiator (In Tank Oil Cooler) Installation Note
1. The automatic transaxle oil cooler flushing must be performed whenever a transaxle is removed for service
because the existing fluid may be contaminated, and to prevent contamination of new fluid.
Note
• The flushing must be performed after installation of the overhauled or replacing transaxle.
2. Follow the instructions in the manufacturers publication for flushing operation.
Oil Pipe, Hose Clamp, Oil Hose Installation Note
1. Apply compressed air to cooler-side opening, and
blow any remaining grime and foreign material
from the cooler pipes. Compressed air should be
applied for no less than one minute.
A6E5614W080
1Oil hose
(See K40 Oil Pipe, Hose Clamp, Oil Hose
Installation Note.)
2 Hose clamp
(See K40 Oil Pipe, Hose Clamp, Oil Hose
Installation Note.)
3 Connector bolt
4 O-ring
5 Radiator (in tank oil cooler)
(See K40 Radiator (In Tank Oil Cooler) Installation
Note.)
A6E5614W070