DYNAMIC STABILITY CONTROL
P35
P
DSC SYSTEM INSPECTION
A6E692067650W01
Preparation
1. Verify that the battery is fully charged.
2. With ignition switch on, verify that the ABS warning light goes out after 2.4 seconds.
3. Turn the ignition switch off.
4. On level ground, jack up the vehicle and support it evenly on safety stands.
5. Shift the transaxle to N position.
6. Release the parking brake.
7. Rotate the wheels by hand, and inspect for brake drag.
Operation of DSC Inspection
1. Perform the Preparation.
2. Connect WDS or equivalent to the DLC-2.
3. Set up an active command modes inspection
according to the combination of commands
below.
Note
• When working with two people, one should
press on the brake pedal, the other should
attempt to rotate the wheel being inspected.
Pressure retention
DYNAMIC STABILITY CONTROL
A6E3970W002
Command name
Wheels
LF RF LR RR
LF_TC_VLV
OFF
RF_TC_VLV
LF_DSC_V
RF_DSC_V
ABS_POWER ON
LF_INLET ON
OFF
OFF
OFF
LF_OUTLET
OFF
LR_INLET ON
LR_OUTLET
OFF
RF_INLET ON
RF_OUTLET
OFF
RR_INLET ON
RR_OUTLET
OFF
PMP_MOTOR
To Next Page
Loading...
