Mazda 6 2002 - Page 645

P88
ON-BOARD DIAGNOSTIC (DYNAMIC STABILITY CONTROL)
End Of Si e
DTC C1280, C1730, C1951, C1952, C1959
A6E697367650W17
Caution
•
••
• When attaching the tester lead to the DSC HU/CM connector the SST (49 G066 004) must be used.
2 VERIFY TROUBLESHOOTING COMPLETED
• Clear DTC from memory.
(See P46 Clearing DTCs Procedures)
• Start engine and drive vehicle at 10 km/h
{6.2 mph} or above.
• Gradually slow down and stop vehicle.
• Is same DTC present?
Yes Replace DSC HU/CM, then go to next step.
No Go to next step.
3 VERIFY AFTER REPAIR PROCEDURE
• Is there any other DTC present?
Yes Go to applicable DTC inspection.
No Troubleshooting completed.
STEP INSPECTION ACTION