Mazda 6 2002 - Page 787

WINDOW GLASS
S69
S
Reusing Glass
Note
• Before removing the rear window glass from the body, mark the position of the glass by affixing tape to
the glass and body panel.
1. Make a hole through the sealant, avoiding pins,
from the inside of the vehicle using an awl.
2. Pass the SST (piano wire) through the hole.
Warning
•
••
• Using a SST (piano wire) with bare hands
can cause injury. Always wear gloves
when using a SST (piano wire).
3. Wind each end of the SST (piano wire) around a
bar.
Note
• Use a long sawing action to spread the work
over the whole length of the SST (piano
wire) to prevent it from breaking.
A6E7738W010
A6E7738W011