T138
AIR BAG SYSTEM
8. Control the SST (Deployment tool) to the SST
(Adapter harness).
9. Connect the red clip of the SST (Deployment tool)
to the positive battery terminal and the black clip
to the negative battery terminal.
10. Verify that the red light on the SST (Deployment
tool) is illuminated.
11. Make sure all persons are standing at least 6 m
{20 ft} from the vehicle.
12. Press the activation switch on the SST
(Deployment tool) to deploy the curtain air bag
module.
Pre-tensioner seat belt
1. Remove the pre-tensioner seat belt. (See S100 FRONT SEAT BELT REMOVAL/INSTALLATION.)
Warning
•
••
• If the pre-tensioner seat belt is not properly installed to the tire, serious injury may occur when the
pre-tensioner part is deployed. When installing the pre-tensioner seat belt to the tire, make sure
the pre-tensioner part is inside the tire.
2. Connect the SST (Adapter harness) to the pre-
tensioner seat belt as shown in the figure.
3. With the pre-tensioner part inside the tire, tie the
pre-tensioner seat belt to the tire. Wrap the wire
harness through the tire and around the pre-
tensioner seat belt at least four times.
A6E8130W055
A6E8130W028
A6E8130W030
A6E8130W041
To Next Page
Loading...
