J2–10
MANUAL TRANSAXLE
Manual Transaxle Installation Note
1. Set the transaxle on a jack and lift into place.
2. Install the transaxle mounting bolts.
3. Install the stud of the No.4 engine mount.
Tightening torque
27.4—40.2 N·m
{2.80—4.09 kgf·m, 20.2—29.6 ft·lbf}
4. Tighten the SST (49 E017 5A0)so that the engine
is located at the specified position.
No.4 Engine Mount Installation Note
1. Verify that the No.4 engine mount rubber is installed as shown.
2. Lightly tighten the bolt A and B.
3. Align the contacted area to front frame of the bolt C to the front frame.
4. Tighten the bolt A, then bolt B.
5. Tighten the bolt C, then bolt D.
Tightening torque
A,B,C,D: 58.8—80.4 N·m
{6.00—8.19 kgf·m, 43.4—59.2 ft·lbf}
6. Verify that the No.4 engine mount bracket is
installed as shown.
7. Lightly tighten the bolt E.
8. Set the transaxle on a garage jack and lift it.
9. Align the hole of the No.4 engine mount bracket
with the stud bolts of transaxle.
10. Lightly tighten the nut F, G and bolt H.
11. Tighten the nut F, G in order of F→G, then bolt H.
A6E5212W022
STUD
A6E5212W020
D
H
C
F
B
A
GE
A6E5212W024
TRANSAXLE
GARAGE JACK
A6E5212W023
To Next Page